Home > Ice Maker > Whirlpool Gold Ice Maker Not Making Ice

Whirlpool Gold Ice Maker Not Making Ice

Contents

Steve Jenkins Hi, Amy. Note, that even if the above test passes, there is another test for the optics board to test another function of the optic boards. music to the ears.Thanks for your help.Jon - [email protected] (remove NOSPAM for a valid email address) Helping Fix Ice Makers in Canada too! Any of these instructions may void or limit warranties provided by the manufacturers. have a peek here

The water filter should be replaced about every six months to maintain proper water flow and ensure water quality. Part Testing Watch this helpful video to determine if this may be the cause of your issue. I jumped on YouTube and found this excellent video explaining how to remove the ice maker. Open the freezer door and observe the red status light next to the ice maker’s on/off switch.

Whirlpool Gold Ice Maker Not Making Ice

Show more Language: English Content location: United States Restricted Mode: Off History Help Loading... This should power up the water valve and water should enter the icemaker. Note that I recommend changing the entire icemaker if the thermostat is bad.If the icemaker will not go through the cycle the motor modular(part number 8201515) is bad and needs replacing. Make sure the power has been disconnect from the refrigerator.5.

  • RepairClinic.com 131,704 views 3:46 Ice maker repair - How to remove Whirlpool Kitchenaid Kenmore - Duration: 2:01.
  • Cause 8 Door Switch The door switch turns off the ice and water dispenser when the refrigerator door is open.
  • Glad you have the parts on hand so your downtime is minimal when it does! 🙂 Steve Jenkins It could be the switch that triggers the dispenser motor, or it could

Guns. RepairClinic.com 71,313 views 3:02 Refrigerator Icemaker Shut Off Arm (part #WP67004028) - How To Replace - Duration: 3:37. You assume all responsibilities by purchasing any of the offered fixes. Whirlpool Refrigerator Not Making Ice But Water Works The most...

When you do this, the icemaker should go through the cycle, the feeler arm should lift up and the water should enter the icemaker. Ice, Ice, baby! I installed the part and now I have ice. If this is the case, just close the freezer door and wait a few minutes until you hear the ice drop and the water tray finishing filling with water.

Be careful if you use the heat gun, they can melt more than ice. Whirlpool Ice Maker Removal Thank you so much for your service. Find out more » Total: $85.61 Add to Cart Cause 6 Low Water Pressure from House Supply The home may have insufficient water pressure. If the door switch does not have continuity when activated, replace it.

Whirlpool Ice Maker Infrared Sensor

The optical boards function the same however, their diagnostic functions differ. http://www.stevejenkins.com/blog/2015/04/how-to-cheaply-fix-a-kitchenaid-whirlpool-ice-maker-by-just-replacing-it/ Link for Access for Ice Maker Repair If you have already paid for your access, here is the link to access the repair instructions (you must have the username and password Whirlpool Gold Ice Maker Not Making Ice I used the "wire trick" to attempt to manually trigger the ice making process. Whirlpool Ice Maker Not Getting Water it'll open in a new page and when you click on it..

Put the jumper across the black and black with white wires as shown in the photo. navigate here Keep this in mind as you figure your total cost to fix your refrigerator. Step 1. Proceed to step 2. Whirlpool In Door Ice Maker Not Working

Using the new part number, I started shopping for replacements. Sign in Share More Report Need to report the video? In addition to the step by step pictures and details to change those boards, you will to need to get replacement optical boards. http://protectfileapps.com/ice-maker/whirlpool-ice-maker-not-making-ice.html Whirlpool Icemaker Repair-Optics Test In this section of this Whirlpool icemaker repair guide I will walk you though diagnosing the ice level optics on Whirlpool refrigerators with the ice-bin mounted in

Close the left side flapper door and make sure you are not blocking the optics board’s light path. Whirlpool Ice Maker Manual All rights reserved. Is there any ice in it?

ApplianceVideo.com 48,262 views 8:14 Refrigerator Ice Maker Not Making Ice | www.goodappliancesuperstore.com - Duration: 3:08.

The temperature should be around 0-10 degrees. Note the normal position for the ice maker armature to be in when NOT in harvest mode is shown in Figure 10 below. Nick Nicoloudis 149,574 views 8:46 Troubleshooting Ice maker repair Whirlpool Kitchenaid Whirlpool - Duration: 8:13. Whirlpool Ice Maker Optics Test Secondly, if I may ask a semi-unrelated question, I cannot seem to remove the ice bin.

Loading... n4ktz 498,781 views 3:52 Ice Maker not making or dispensing ice -Level Optics Board-Whirlpool,Kenmore ,KitchenAid # 4389102 - Duration: 8:14. ApplianceVideo.com 214,971 views 9:23 Whirlpool Refrigerator Ice Maker Problems - Duration: 2:39. this contact form Savings: $148.51 What People are Saying about this Repair: Ice Maker Repair - What this web site is all about...

Plus AppliancePartsPros.com supports this website, so by supporting them your supporting appliance-repair-it.com, keeping it up and running for your appliance repair needs. As these refrigerators get older, the optics boards are more likely to fail. Add to Want to watch this again later? I just wish I had found your site three months ago!

It is mostly used just the make the icemaker cycle to see what it is doing or not doing. The valve requires at least 20 psi to function properly. Almost every batch of ice needs to have a few remaining cubes manually removed from the ice making compartment to the door holding tank. ApplianceVideo.com 50,193 views 9:59 Refrigerator Repair- Replacing the Electronic Control Boards (Whirlpool Part # 4389102) - Duration: 4:46.

Follow ApplianceAssistant on Twitter! It is pretty easy to check to see if the optic boards are working (and just as easy to fix the problem with these instructions and the proper parts). EXCEPT AS SPECIFICALLY PERMITTED HEREIN, NO PORTION OF THE INFORMATION ON THIS WEB SITE MAY BE REPRODUCED IN ANY FORM, OR BY ANY MEANS, WITHOUT PRIOR WRITTEN PERMISSION FROM ABSOLUTE TECHNOLOGIES, It only took the appliance store about a day to get the part in (the part was a little pricier than you quoted, about $90 w/ tax).

You should be able to do it for under $90.